EtherChannel PAgP LACP 以太通道

desirable means try and negotiate with the other side, and if he agrees, then enable the channel. If you have on on one side and ...

2009年10月1日 — Switch(config-if)#channel-group 10 mode ? active Enable LACP unconditionally auto Enable PAgP only if a PAgP device is detected desirable Enable ...

2020年9月9日 — A port in the desirable mode can form an EtherChannel with another port that is in the desirable or auto mode. A port in the auto mode can form ...

... EtherChannel only have the channel-group command: SW1#show run interface GigabitEthernet 0/1 interface GigabitEthernet0/1 channel-group 1 mode desirable end

設定方法亦不難，只要用channel-group 1 mode desirable 來設Desirable Mode 和用channel-group 1 mode auto 來設Auto Mode 即可。 etherchannel. SW1(config)# ...

设定方法亦不难，只要用channel-group 1 mode desirable 来设Desirable Mode 和用channel-group 1 mode auto 来设Auto Mode 即可。 etherchannel. SW1(config)# ...

2021年3月14日 — PAgP desirable: In this mode, PAgP negotiations with other interfaces by sending PAgP packets. PAgP auto: In a passive negotiating state,. LACP:.

2021年4月7日 — The answer is C because SW2 is running PAgP (Cisco Proprietary). channel-group 1 mode desirable enables PAgP. channel-group 1 mode active ...

2023年4月15日 — EtherChannel works by grouping ... S1(config)# interface fa0/1 S1(config-if)# channel ... Here, the user has used the mode desirable and switch-port ...

端口聚合channel-group 1 mode desirable ... Command rejected: An interface whose trunk encapsulation is Auto can not be configured to trunk mode.